David Mason's Cenobites
"Thought I would send you some pics of custom 4 inch Cenobites I made after having a Halloween challenge put to me at a custom figure website. They are made from a mix of GI Joe, PTE and Star Wars figures.
The recipes for the figures are:
Pinhead:
Head: Star Wars Lobot, all holes drilled with 0.15mm drill bit and filled with 0.1mm jewellers wire
Torso/Arms: GI Joe Sand Scorpion
Skirt:Star Wars Ep. III Tion Medon
Female:
Head: ST: Motion Picture Ilia with wire inserted
Torso/Arms: GI Joe VvV Scarlett
Skirt: modelling clay
Knives: R/hand- GI Joe swamp rat, L/Hand- milliput
Butterball:
Head: Sculpted
Torso/Arms: GI Joe Hard Drive
Skirt: modelling clay
Instruments: various
Chatterer:
Whole figure: PTE diver
Head: Sculpted
Dio:
Styrene sheets with printed background. Chains are hanging from ceiling piece.
Pillar of Souls: wooden block with picture of pillar glued on. The chains are thin ones I got from a hardware store and cut to length. I then put a ceiling piece on the background piece I use for other figures and drooped the chain through them. I deliberately left the top piece off the photo to give the impression that the chains are just hanging in mid air.
  |
 |